This occasional accent chair is a charming piece that has been created in contemporary transitional style. The perfect piece to combine with its coordinating collection, or to place with an array of existing furniture pieces, this stunning accent chair features a stream-lined design with a fine fabric upholstery that creates an aesthetic modern look. Exposed wood feet and slightly flared arms keep this chair corresponding with traditional design elements, allowing it to blend in with nearly any new or existing furniture style.
The 5600 Occasional Accent Chair, made by Serta Upholstery by Hughes Furniture,
is brought to you by Rooms for Less. Rooms for Less is a local furniture store, serving the Columbus, Reynoldsburg, Upper Arlington, Westerville Ohio area. Product availability may vary.
Contact us for the most current availability on this product.
Exposed Wood Leg
Item & Dimensions
Serta Upholstery by Hughes Furniture
Width (side to side)
Depth (front to back)
Height (bottom to top)
Fabric & Upholstery
Available in Upholstery Shown
Contemporary Track Arms with Slight Outward Flair
Tight Pulled Seat Back with Contemporary Silhouette
Plush Upholstered Seat Cushion for Superior Seated Comfort
Leg or Skirt
Contemporary Tapered Block Legs
Exposed Wood Leg
Construction & Warranty
Frames are built in-house with hardwood, such as oak, ash, birch, or maple (70%) and plywood or OSB (30%). Lumber is cut and graded in Manufacturers own machine room to help insure quality for the foundation of our recliners. Only hardwood lumber is used, never plywood or OSB in stress points or load-bearing areas of frames. Individual frame pieces are reinforced in the corners and stress points by glue, blocks and staples, much more preferable than nails or screws.
Springs are machine tested for durability and lasting support. A sturdy frame provides an anchor for good seating support, while the filling or cushion, augments it. In frames, 8 gauge no-sag wide loop sinuous springs are “s” shaped and run from the front of the seat to the back. An additional 16-gauge stakewire is attached across from side to side to support these springs. This process is done by pneumatically clamping the springs together to tie the individual springs into one unit to prevent the springs from separating or twisting. Back spring clips are autolocking and are made from nylon to help reduce noise. Back springs are 12-gauge sinuous wire. Seat spring clips are constructed from metal to provide strength and are nylon-lined, reducing noise. This makes for a strong seat and provides superior support.
Padding & Ergonomics
Seat cushions and frame parts are fabricated in manufacturer’s own foam fabrication facilities to control the quality and feel of each piece. Cushion thickness is kept at a minimum of 4.5 inches to promote comfort and support. Cushions are fabricated from superior (1.8 lb. density, 34-lb. compression) foam and wrapped in 1oz. or 1.8 oz Dacron for comfort and protection. All foams are made with Environmentally-friendly Polyol derived from soy beans and castor beans that require up to 60% less fossil fuel resources than petroleum-based polyols (for every 11 pounds of plant-based polyol, a gallon of crude oil is saved. This results in 36% less global warming emissions). Test results are monitored from every shipment, every day to maintain consistency.
Backs and pillows are air-blown with polyurethane foam or polyester fiber to contour to the body for maximum support and comfort.
Construction & Materials
Fabrics are cut and sewn in each of this manufacturer’s plants. This allows greater flexibility in scheduling and helps monitor quality. One-half inch seams are used and components are sewn together at a minimum of 5 1/2 to 6 seams per inch.